The Delete End TAA  License command provides a method  of resetting the
TAA license  if ENDTAALIC had  been used previously.   This is intended
for  a situation  where a mistake  has been made  or a  change of plans
has occurred  after  ending  the TAA  license.   DLTENDLIC  requires  a
special software code  that may be requested from  the TAA Productivity
Tools owner.

You must have *ALLOBJ authority to use DLTENDLIC.

A typical command would be:

             DLTENDLIC   CODE1(xxxx) CODE2(yyyy) ...

This  would create a temporary license that  would be good for 30 days.

DLTENDLIC escape messages you can monitor for
---------------------------------------------

None.  Escape messages from based on functions will be re-sent.

DLTENDLIC Command parameters                          *CMD
----------------------------

   CODE1         A 4  byte  value  supplied  by  the  TAA  Productivity
                 Tools owner to reset the TAA license information.

   CODE2         A 4 byte value like CODE1.

   CODE3         A 4 byte value like CODE1.

   CODE4         A 4 byte value like CODE1.

   CODE5         A 4 byte value like CODE1.

   CODE6         A 4 byte value like CODE1.

   CODE7         A 4 byte value like CODE1.

   CODE8         A 4 byte value like CODE1.

   CODE9         A 4 byte value like CODE1.

   CODE10        A 4 byte value like CODE1.

Restrictions
------------

You must have *ALLOBJ authority to use DLTENDLIC.

Prerequisites
-------------

The following TAA Tools must be on your system:

     CHKTAALIC       Check TAA license
     RTVTAALIC       Retrieve TAA license

Implementation
--------------

None, the tool is ready to use.