TAA Tools

The  Display  ASP   (Auxiliary  Storage  Pool)  Attributes   2  command
displays  or prints  a brief  description  of the  important attributes
and  status information about an ASP.   This includes the total storage
capacity, the percent used,  the amount of remaining storage,  the type
of ASP,  the threshold  percent, and the  amount of  overflowed storage
if any.

A typical command would be:

             DSPASPA2     ASP(2)

An OUTPUT parameter exists to allow the results to be printed.

DSPASPA2 escape messages you can monitor for

      TAA9893    The ASP does not exist

Escape messages from based on functions will be re-sent.

Command parameters                                    *CMD

   ASP           The  number of  the ASP to  be displayed.   Basic ASPs
                 must be a value  between 1 and 32.   If a device  name
                 is requested,  this parameter  must be defaulted  (a 0
                 value is passed).

                 Primary  or  secondary ASPs  are  known  externally by
                 their name although  a number  between 33  and 255  is
                 assigned by the system.   If you know the  name of the
                 primary or  secondary ASP, you should  use the default
                 for  this parameter and  enter the name  in the ASPDEV

                 If the  number  of the  primary  or secondary  ASP  is
                 known,  but  the  ASP  device  name is  not  known,  a
                 number  between 33 and 255 may  be entered to retrieve
                 the information  about  the  ASP.    This  allows  the
                 device name  of the  ASP to be  displayed if  only the
                 number is known.

   ASPDEV        The  ASP device name  to retrieve.   If an  ASP number
                 is requested, this parameter must be blank.

   OUTPUT        How the  output  should  occur.   *  means  a  display
                 appears  if the  command is  used  interactively.   If
                 the command  is run in  batch or *PRINT  is specified,
                 a spooled file is output.




The following TAA Tools must be on your system:

     EDTVAR          Edit variable
     RTVASPSTS       Retrieve ASP status
     SNDCOMPMSG      Send completion message


None, the tool is ready to use.

Objects used by the tool

   Object        Type    Attribute      Src member    Src file
   ------        ----    ---------      ----------    ----------

   DSPASPA2      *CMD                   TAAASPE       QATTCMD
   TAAASPEC      *PGM       CLP         TAAASPEC      QATTCL

Added to TAA Productivity tools December 15, 2000

Home Page Up to Top