DSPTAPLBL DISPLAY TAPE LABEL TAATAPS |
The Display Tape Label command displays or prints basic information
about a tape label including the date the first file was written and
the first expiration date. DSPTAPLBL is very efficient in displaying
information from a virtual tape. The command can be very slow when
certain tape devices are used.
A typical command would be:
DSPTAPLBL DEV(xxx)
The information from the tape (or virtual tape) would be displayed.
DSPTAPLBL escape messages you can monitor for
---------------------------------------------
None. Escape messages from based on functions will be re-sent.
Command parameters *CMD
------------------
DEV The name of the device where the tape (or virtual
tape) exists.
VOL The volume ID to retrieve.
*MOUNTED is the default.
A specific volume ID may be entered in 6 characters
or less.
OUTPUT How to output the results. * is the default to
display the spooled file if the command is entered
interactively. The spooled file is deleted after it
is displayed.
If the command is entered in batch or *PRINT is
specified, the spooled file is output and retained.
Restrictions
------------
None.
Prerequisites
-------------
The following TAA Tools must be on your system:
RTVDEVTAP Retrieve device tape
RTVSYSVAL3 Retrieve system value 3
RTVTAPLBL Retrieve tape label
SNDCOMPMSG Send completion message
SNDESCMSG Send escape message
Implementation
--------------
None, the tool is ready to use.
Objects used by the tool
------------------------
Object Type Attribute Src member Src file
------ ---- --------- ---------- ----------
DSPTAPLBL *CMD TAATAPS QATTCMD
TAATAPSC *PGM CLP TAATAPSC QATTCL
TAATAPSR *PGM RPG TAATAPSR QATTRPG
|
Added to TAA Productivity tools September 15, 2006